Instructions for fastening the rubber floorings / cubicle covers
Instructions for fastening the rubber floorings / cubicle covers

Fastening:

Follow this sequence:

drill

drilling: step 1 when fastening KRAIBURG rubber floorings

pound the plastic plugs in flush

pound plastic plugs in flush: step 2 when fastening KRAIBURG rubber floorings correctly pound in plastic plug: flush with the mat

pound in nails / fasten screws (with washers)

pound in nails: step 3 when fastening KRAIBURG rubber flooringsfasten screws: step 3 when fastening KRAIBURG rubber floorings

Use longer nail plugs in mastic asphalt (10×120mm)!

Tip: pulling the drill out at regular intervals during drilling extracts the dust from the hole.

Pound in nail plugs, i.e. fasten screws, until they are seated evenly fast and are slightly countersunk

 

Tip: Check to see if the fastening can be felt with a flat object made of metal (e.g. hammer) by sliding it over the fastening. If it can be felt, pound it in deeper!

A small gap should be visible!

check if nails or screws are countersunk: slide over with hammer 

Do not pound fastenings in too deep / do not overtighten!
No tension should develop; the mat should not bulge!

do not pound fastenings in too deep, the mat should not bulge

Important:

Proper installation can vary due to individual conditions at the site. For this reason, the manufacturer can fundamentally not be held liable for the installation!

Further guidelines for correct installation are in the installation instructions » for the respective product. These are available in many languages.